Eng_Multi-MU

SINCE 1 9 1 1

Registration of up to 11 measuring quantities in alternating current systems and three or four wire three phase alternating current systems with equal or any other loading

Multi-K-MU with 11 double outputs,
Multi-K4-MU with 4 double outputs

Two limit value or impulse outputs

Configurable via USB interface

Display and evaluation of the measuring
values on the PC

galvanic separation up to 5,2 kV

Application
The measuring converter Multi-K-MU and Multi-K4-MU serves for the simultaneous conversion and separation of current, voltage, frequency, active power, reactive power, apparent power and the power factor with any shape of curve in 11 (resp. 4 in case of Multi-K4-MU) load independent direct current and direct voltage signals. The 11 quantities being measured can be displayed, stored and configured through a USB interface on the PC. In case of Multi-K4-MU the 11 quantities can be configured and given in any combination out on the 4 double outputs.
Two further outputs can be used as limit values or impulse outputs.


	Technical data

*Input*	Input parameters Nominal current Current range Nominal voltage Voltage range Nominal frequency Frequency range	alternating current, alternating voltage, frequency, active power, reactive power, apparent power and power factor in the alternating current system, four wire and three wire three phase alternating current systems with equal or any other loading, one or two sided energy directions, configurable 2A and 6A 0.3 – 10 A, configurable 100 to 750V 40 – 750 V, configurable 50Hz 40 - 80Hz
*Analogue outputs*	Output parameters Nominal value current Nominal value voltage Polarity - Multi-K-MU Polarity - Multi-K4-MU	load independent direct current and load independent direct voltage 0 – 10 mA, 0 – 20 mA, 4 – 20 mA, configurable 0 – 5 V, 0 – 10 V, 2 – 10 V, configurable 4 x unipolar or bipolar ,7 x unipolar, configurable 4 x unipolar or bipolar ,configurable
Limit value and impulse outputs	Typ Operating voltage Operating current Length of impulse Hysteresis Accuracy	Open collector, (NPN- transistor) 5 - 24V DC, max. 30V DC max. 40mA about 40 ms (pause > 100 ms) about 4 % of the set limiting value +/- 1.0% of full scale value
Transmission behaviour	Accuracy Setting time Test voltage	+/- 0,5% about 200 ms (power factor about 600 ms) 4 kV between output to auxiliary voltage, 5.2 kV between input to output and input to auxiliary voltage, 2 kV between limit value or impulse output to output
*Regulations*	Electrical safety	DIN EN 61010 Part 1 Housing all insulated, protection class II, at a working voltage up to 600 V (network to neutral conductor) degree of polution 2, overvoltage category CAT III
*Auxiliary voltage*		10 – 30 V AC + DC or 60 – 265 V AC + DC
*Dimensions*	Multi-K4-MU Multi-K-MU	90 x 84 x 108mm 135 x 84 x 108mm
*Accessories*		Software inclusive USB cable

Multi-K-MU Documents

Data sheet (pdf-document)
Multi-K-MU software description (pdf-document)

Multi-K4-MU Documents

Data sheet (pdf-document)
Multi-K4-MU software description (pdf-document)